Komatsu — 11.4 CONTROL LEVERS AND PEDALS

11. EXPLANATION OF COMPONENTS 9. SAFETY LOCK (For ripper control lever) a WARNlNG, p When leaving the operator’s compartment, set the safety lock securely to the LOCK position. If the control lever is not locked, and it is touched by mistake, this may lead to a serious accident. If the safety lock is not placed securely in the LOCK position, the control lever may not be properly locked. Check that the situation is as shown in the diagram. When parking or servicing the machine, be sure to lower the ripper and set the safety lock in the LOCK position. AE104810 This device is used to lock the ripper control lever. 10. PIN PULLER CONTROL SWITCH This is used to operate the pin puller.

I 0 0 N PULL OUT: Pin is pulled out. PUSH IN: Pin is pushed in. Neutral: Pin is pushed in and held position. in N ALll5eeO 11. BRAKE PEDAL A WARNING Do not place your foot on this pedal unnecessarily. Depress the pedal to apply the right and left brakes. AElO4830 12. DECELERATION PEDAL l Do not place your foot on this pedal unnecessarily. l When passing over the top of a hill or when a load is dumped that the travel speed will also increase suddenly. To prevent / AE104840 This pedal is used for reducing the engine speed or stopping the machine. When switching between forward and reverse, or when stopping the machine, use this pedal to reduce speed. 2-21