Komatsu — 12.11 RIPPER OPERATION

12.11 RIPPER OPERATION 12.11.1 EFFECTIVE METHOD OF USE l The optimum digging angle for the shank is when the shank is perpendicular to the ground (ripping angle: 45”- 50” 1. l In comparatively soft rock (seismic velocity: 1500 m/s or below), it is also possible to carry out ripping with the shank tilted to the rear. l On comparatively hard rock, if ripping is carried out with the shank tilted to the rear, there will be excessive wear of the point of tip @ , and the self-sharpening ability will be lost. l During ripping operations, if the shoes slip because of boulders or resistance from the bedrock, use the tilt cylinder.

When picking up a stone, advance the machine at a fixed gear speed (Fl or F2). AE105d90 REMARK When raising boulders or digging up rockbed, do not put the transmission in neutral. If the transmission is in neutral, the reaction of the tilt cylinder will push the machine back. Always operate the machine with the transmission in FORWARD. REMARK Choosing a suitable ripper point to match the type of rock is one of the most important elements in using the ripper effectively. Ripper points are available for different types of rock, so select the most suitable ripper point from the list. For details, see “30.

PROCEDURE FOR SELECTING RIPPER POINT.” 12.11.2 DIGGING UP BOULDERS OR ROCKBED During ripper operations, if stubborn boulders or rockbed cause the travel speed to become slower, operate the tilt cylinder to dig up the boulder/rockbed. 2-64