12.11.3 OPERATING ON SLOPES When using the variable ripper, adjust cylinder to select dimension I_. the length of the tilt AE105510 12.11.4 TANDEM OPERATION When it is impossible for one machine to carry out ripping under its own power, ripping can be carried out in tandem. AE105520 12.11.5 METHOD OF OPERATING PIN PULLER This is used only on machines equipped with a giant ripper. Stop the machine in a safe place and lower the shank to the ground. 1. 2. Operate the pin puller controller switch to the PULL OUT position and remove the mounting pin. 3. Move the rioter uo or down to set to the desired shank oosition. 1 AE105550 4. Operate the pin puller control switch to insert the mounting pin.
If the pin does not match the position of the hole in the shank, set the pin puller control switch to the PUSH IN position and slowly move the ripper up or down. Top surface Depth l When raising the pin position to increase the digging depth, use a long protector to prevent wear of the shank. 2-65