. MAINTENANCE SERVICE PROCEDURE WARNING WATER SEPARATOR, DRAIN WATER (PAGE 3-70)". 4 - 26 CHECK ADDITIONAL WATER SEPARATOR, CLEAN INSIDE OF CASE (ONLY POOR FUEL ARRANGEMENT SPECIFI CATION) The engine fuel piping system is under high internal pressure when the en gine is running. Always reduce the internal pres before draining water or repla cing the element cup. Do not bring fire close. This engine consists of higher precision parts than on the conventional f uel injection pump and n ozzle, so if dir t gets in, i cause problems. If there is an y dirt stuck to the fuel line, use fuel to wa sh it off completely.
NOTICE When carrying out inspection and maintenance of the fuel system, the p articularly careful not to let any dirt o r dust get there is any dirt of dust aroun d the fuel system, clean it off thoroughly w ith fuel before starting t he operation. To prevent dirt or dust from g etting into the fuel circuit, remove all dirt an d dust from the surroun ding area before startin operation. Prepare a container to cat 1. Drain the water and fuel . For details, see "CHECK ADDITIO (ONLY POOR FUEL AR 2. Loosen the ring nut (1), t 3. Pull screen (5) down to holder (3). 4. Wash screen (5) in clean Check screen (5) and rep 5. Wash the inside of case ( Check case (2).
If it is sc the position of float (6) ca 6. Wash the inside of water 7. Install screen (5) to the w 8. Replace O-ring (7) with a 9. Tighten plug (4) and inse rt in case (2). Be careful not to let flo at (6) be at Tightening torque: 2.0 - 3 .0 Nm (0.20 - 0.31 kgm, 1.4 - 2.2 lbft) 10. Install case (2) to the wat er separator holder (3), then tighten ri ng nut (1). Tightening torque: 23 - 2 7 Nm (2.4 - 2.8 kgm, 17.0 - 19.9 lbft) 11. After completing the insp ection and cleaning, bleed the air. Use the same procedure a s when replacing the filter cartridge. For details of the method of bleeding the air, see "REPLACE FUEL PRE-FILTER CARTRIDGE (PAGE 4-6 UEL PRE-FILTER CA RTRIDGE (PAGE 4-6