. OPERATION EXPLANATION OF COMPONENTS change from 3 - 46 Condition s for switching fan r When using manual reverse rotation f Switching fro m normal rotation to rev The fan will switch from normal ro tation to reverse rotation only if all the followin g condition s are fulf If the direct ion is switched, the c machine flashing an d will stay lighted up. If all the co nditions are not fulfilled , the fan direction will no If the direct cooling fan reverse rota tion pilot lam p on the flash.
Conditions Position (b) of the cooling fan a uto reverse rotation swit ch is pressed The eng ine speed is between Li and 1200 rpm (If the H ST oil temperature is a bove 30°C, the engine s peed conditio n does not apply.) The eng ine water temperature is less than 102 The HST oil temperature is bel At least 30 seconds has passe d since the engine was s monitor will continue to Switching fro m reverse rotation to nor mal rotation tation to normal rotation if any of the following conditions are fulfilled.
The fan will switch from reverse ro tation to normal rotation if any of the following condition s are fulfi If the directi on is switched, the coo ling fan reverse rotation p ilot lamp on t he machine monito r will cha nge as follows: Lighted up -> flashing -> OFF. d, the fan direction will not change. If none of th e conditions are fulfille d, the fan direction will n If the directi on is not switched, the cooling fan reverse rotat ion pilot lam p on the machine m onitor wi ll change from being lighte d up to flashing and wi Conditions If the HST o il temperature is abov e 20°C, the following eng ine speed c onditions do not apply.
At least 10 minutes has passed since the fan switched to reverse rota tion and t he engine speed is less than 1200 rpm. Position (a) of the cooling fan r everse rotation switch w as pressed a gain during reverse rotation of the fan and the engi ne speed is less than 1 200 rpm.