. OPERATION EXPLANATION OF COMPONENTS When using automatic reverse rotation function 3 - 47 Switching from normal rotation to reverse rotation l rotation to reverse rotation only if all the following conditions are fulfilled. e cooling fan reverse rotation pilot lamp on the machine monitor will change from p. lled, the fan direction will not change. The fan will switch from norma l rotation to reverse rotation only if al l the f ollowing conditions a re fulfilled.
If the direction is switched, th flashing and will stay lighted u If all the conditions are not fulfi lled, the fan direction will not change If the direction is not switched, the cooling fan reverse rotation pilot lamp on the m achine mon itor will change from OFF to flashing and will contin ue to flash. n auto reverse rotation switch is pressed. ure is less than 102°C. above 13°C and below 100°C. elow 80°C ssed since the engine was started. hing has passed. Conditions Position (a) of the cooling fa n auto reverse rotation switch is pressed. The engine water temperat The HST oil temperature is The boost temperature is b At least 30 seconds has pa ssed since the engine was started.
The specified time for switc change from Switching from reverse rot ation to normal rotation e rotation to normal rotation if both of the following conditions are fulfilled. The fan will switch from revers e rotation to normal rotation if both of the f ollowing conditions a re fulfilled. If the direction is switched, the cooling fan reverse rotation pilot lamp on th e machin e monitor wi ll change as follows: Lighted up -> flashing -> OFF. fulfilled, the fan direction will not change. If neither of the conditions are If the direction is not switched, the cooling fan reverse rotation pilot lamp on the m achine mon itor will change from being lighted up to flashing an d will continue to flash.
Conditions A position other than positio n (a) of the cooling fan auto reverse rotation switch i s pressed du ring reverse rotation of the fan. for continuous running of automatic fan reverse operation. After completion of the time for continuous running of automatic fan re verse op DIRECTIONAL SELECTOR SWI TCH ACTUATION SWITCH When this switch (6) is turned ON, the function of the directional lector switch is actuated. elector pilot lamp on the machine lector switch is turned off. selector switch is actuated. Position (a): ON The directional se The directional s monitor lights up. Position (b):
OFF The directional se REMARK Turn this switch ON when t he directional lever and directional selector switch are at the ne utral position. At any other position, this switch does not work. tor switch is functioning, when the Even if the directional selec directional lever is operate d, the operation of the directional lever is given priority.