Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION ADJUST REAR VIEW MIRROR WARNING securely that they will not be torque cannot be controlled, ask your Komatsu 3 - 103 Be sure to adju st the mirrors before st arting work. If they ar e not adjusted properly, you cannot sec ure the visibility and may be injured or may injure someone serious Mirrors A, B Loosen bolt ( 1) of the mirror, then adjust the mirror to a position which gives t he best view from the operator's seat of t he blind s pot at the left and right sides at the rea r of the machine.

When inst alling the mirror, adjus t so that it is possib le to see any person (or any object of a heigh t of 1 m (3 ft 3 in) a nd diameter of 30 cm ( 11.8 in)) at the rear le ft or right of the ma chine. Mirrors C Adjust so tha t is possible to see the ground around the machin e at a r ange of 1 m (3 ft 3 in) from the o perator's seat. Install the mi rrors at the position and dimensions s hown in the diagram. Th e values below are re ference values for the range of visibility. Range of vie w (left): 2500 mm (8 f t 2 in) ft 2 in) Range of vie w (right): 2500 mm (8 Mirror A: Mus t be possible to see hatched portion (A) Mirror B: Mus t be possible to see hatched portion (B) Mirror C:

Mus t be possible to see hatched portion (C) NOTICE Tighten the mirror mounting bolt loosened an d the mirrors will not co Tightening t Mirrors A, B :2.0 to 2.5Nm (0.2 to 0. Mirrors C :8.8 to 12.7Nm (0.9 to 1.3 If distributor f