Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC).

If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover (600-411-9000). Please consult your Komatsu distributor about the method of installing. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. When deciding the proportions for mixing the coolant with water, investigate the lowest temperature in the past and use the table below to decide the mixing ratio.

Actually, set a temperature that is 10 ° C (50 ° F) lower than the minimum temperature. The mixing ratio differs according to the ambient temperature, but a minimum of 30% by volume is needed (amount of antifreeze/total amount of water in cooling system x 100). Even in areas where it is not necessary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system. The freezing temperature of 100% undiluted super coolant is -15 ° C (5 ° F). Be careful not to store the undiluted super coolant at temperatures below -15 ° C (5 ° F).

4 - 20 Immedi ately after t he engine i s stopped, the e ngine c oolant is hot and the pressure inside th e radiator i s high. Removing t he cap and draining th e water under t his conditio n could cause burns. Allow t he engine to cool d own, then turn the cap slowly to release the pressur e. Start th e engine an d flush the system. Before standing up o r leavin g the o perator's seat, set t he work equipmen t lock lever to the LO CK position.

For det ails of starti ng the engine, see "CHECK BEFOR E STARTING ENGIN E, ADJUST (PAGE 3-88)" and "STARTING ENGINE (PAGE 3-106)" in th e OPERATION section of t he Operation and Maintenan ce Manua When t he undercov er is removed, there is danger of t ouching t he f Never e nter the rea r of the machin e when the engine i s running Stop the machine o n level groun d when cleaning o r changing the co olant. Clean the inside of the coolin g system, change the coolant accordin g to the t able bel Antifreeze coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first