Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE is no display of the UPPER poles appear straight and not bent. added to any cell of cap (1), add 4 - 48 WHEN IT IS IMPOSSIBLE TO CHECK ELECTROLYTE LEVEL FROM SIDE OF BATTER If it is impossible to check the LEVEL line on the side of the b 1. Open the cover of the batte There are two battery boxes : One on each side at the rear o f the m 2. Remove cap (1) at the top of the battery, look through the wat filler port (2), and check the electrolyte surface. If th electrolyte does not reach th e sleeve (3), add distilled water s that the level reaches the bo ttom of the sleeve (UPPER LEVE line) without fail. (A) Suitable level:

Electro lyte level is up to bottom of sleev face tension causes electroly e to bulge and poles appear ben (B) Low: Electrolyte level 3. distilled water also to the ot 4. After adding distilled water, REMARK If distilled water is added to abo syringe to lower the level to the b removed fluid with baking soda ottom of the sleeve. Neutralize th (sodium bicarbonate), then flush away with a large amount of distributor or battery maker. WHEN IT IS POSSIBLE TO USE INDICATOR TO CHECK ELECTROLYTE LEVEL If it is possible to use an indicat or to check the electrolyte level, follow the instructio CHECK PARKING BRAKE se the brake pedal to stop th r fully to the LOCK position, an 1. 2. 3. 1.

On dry downhill slopes, u machine. Pull the parking brake leve 2. check if the parking brake c an hold the machine in position. If any problem is found, distributor. please contact your Komats