. MAINTENANCE SERVICE PROCEDURE CHECK OF ENGINE AIR INTAKE PIPING CLAMPS FOR LOOSENESS 4 - 62 LUBRICA grease pump , pump in grease through t he grease fittings marked by the arrows.
easing, wipe o ff any old grease that was pushed ou (1) Center hinge pin (2 pla Please ask your Komatsu distributor to check t he tig htening of the clamps between the air c leaner - turbocharge - aftercoole CHECK ALTERNATOR DRIVING BELT TENSION AND REPLACEMENT Since insp ection and replaceme nt of th e fan belt req uires special t ools , contact your Komats REMARK The machi ne is equipped with a n auto t ensioner, so there is no need to If the altern ator drive belt i s in the following condition, the belt must be replace d.
Please ask your Komatsu distributor to replace the rizontal scratch (1) crosses vertical scratch (2) ere are tears (3) in part of the belt where there are horizontal scratches only, there is no lace the belt. omatsu he belt. When ho rizontal scratc h (1) c rosses vertical scrat ch (2) When th ere are tears ( 3) in pa rt of th e belt In case (4) where there a need to rep lace the belt. y, there is no