Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC FILTER ELEMENT WARNING temperature immediately after the engine is stopped, and may cause burns. Wait for the see "CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL (PAGE 4-46)". 4 - 63 EVERY 2000 HOURS SER Maintenance for every 50, 100, 250, 500 and 1000 hours service should be carried out at The parts and oil are at high te temperature to go down before s When removing the oil filler cap, Refill capacity: 89 liters (25.5 1. Lower the bucket horizontal ly to the ground and apply the parking brake, then stop the 2. Remove covers (1) and (2). 3. Keep grip (3) pulled, the counterclockwise and remo 4.

Set a container to catch the 5. Loosen drain plug (P), drain again. 6. Using a filter wrench, turn c 7. Clean the filter holder, fill th coat the seal and thread of thinly with grease) and insta When installing the seal, tig contact with the filter holder, 8. Refill the specified quantity 9. Check that the hydraulic oil is 10. Run the engine at low idle, a nd extend and retract the steering, bucket, and lift arm cy linders 4 to 5 times. Be careful not to operate the cyl inder to the end of its stroke (stop approx. 100 mm (3.9 in) b efore the end of stroke).

NOTICE f the engine is run at high speed imm ediately after startup or a cylinder is pushed up to its stroke end, a ir taken inside the cylinder may cause damage to the piston pa cking. 11. Operate the steering, bucke t, and lift arm cylinders to the end of their stroke 3 to 4 tim es, then stop the engine and loosen filler cap to blee d the air from the hydraulic tank. level and add oil to the specified level. For details, see "CHECK OIL LEVEL IN IL (PAGE 4-46)". 12. Check that the hydraulic oil HYDRAULIC TANK, ADD O 13. Next, raise the engine spee d and follow the procedure in Step 11 to bleed the air. Rep eat this process until no more air comes out. d operation, install cover (1) and (2).

14. After completing the air blee