. OPERATION EXPLANATION OF COMPONENTS can be travel TRAVEL ACTION CODE DISPLAY WARNING REMARK "E03" is displayed on the top line of the character display and "CHECK RIGHT NOW" and "CALL" are displayed in turn on the blank. For see NUMBER 3 - 8 ENGINE SPEED OR TRA The bottom line of this di If the speedometer is switched so that the bo speed. To have the speedomet switched, see "ME SPEED/ENGINE SPEE Even if the starting switc engine speed, or machin THOD OF SWITCHING D DISPLAY (PAGE 3-40).
h is at the OFF position, the servi e travel speed will be displayed (U) of machine monitor mode selector switch 1 is kept p NOTICE When the starting switch is at the OFF position, if the service met er, engine speed, or travel speed is being displayed even thought the top part (U) of machine monitor mode selector switch 1 is n ot being pressed , there is probably a failure in the equipment, so please ask your Komatsu d istributor to carry out inspection. If action code E03 is displ ayed, stop the machine immediately and check the failure code. For details, see "FAILURE CODE butor of the failure code and ask for repairs. failure c ode. For details, see "FA ILURE CODE DISPLAY (PAGE 3-10)".
Inform your Komatsu distri butor of the failure code and ask for If there is a failure on the machine, if it is necessary to change the metho d of operation, or if i nspection or maintenance must be c portion (3). arried out, action code E01, E02, or E03 is displayed on the character display in display at the same time, the action code for the more serious problem is displayed. is as follows, starting with the most serious: E03, E02, E01. If different failures occur at the same time, the action co de for the more seriou s proble m is displayed The level of seriousness is as follows, starting with the m ost serious: E 03, E02 , E01.
In the case of action cod es E02, and E03, the alarm buzz er sounds interm ittently and the central warnin g lamp lights up. If action codes E01, E02 , or E03 are displayed on the ch aracter display , stop o peration s, check the c ontent of the display, and take the foll owing action. E03: When this code is displayed, stop the machine imm check the failure c for repairs. bottom line for 3 seco The telephone numb telephone number h details of the metho Section "INPUT M (PAGE 3-36)". as been set, the display is bl d of inputting the telephone num