16. TROUBLESHOOTING 16.4.2 CHASSIS Problem Main causes Remedy Torque converter oil pressure does not rise l Entry of air or leakage of oil caused by damage or improper tightening of oil pipe, pipe joint a Wear, scuffing of gear pump a Lack of oil in transmission case a Check, repair (a Check, replace) a Add oil to specified level.
0 Clean l Clogged oil filter element strainer in transmission case Torque converter overheats a Replace belt Loose fan belt Engine water temperature is high Clogged oil cooler Oil pressure is too low Insufficient flow of oil due to worn gear pump l See section related to engine (0 Clean or replace) l See above (o Replace gear pump) Defective oil temperature gauge Defective contact in wiring . .
(o Replace oil temperature gauge) (o Check, repair) Torque converter oil temperature gauge does not work Lack of drawbar pull (travel speed does not rise) a Lack of engine horsepower a Torque converter oil pressure is too low l See section related to engine l See above a Steering clutch is slipping (o Check, repair) Machine does not move off even when gear shift lever is placed in position a Lack of oil in steering clutch case a Transmission oil pressure does not rise i a Add oil to specified level (a See “Torque converter oil pressure does not rise”) a Steering clutch is slipping 0 Wear, scuffing of gear pump o Clogged oil strainer element in steering clutch case (o Check, replace) o Clean a Adjust When steering lever is pulled on one side, machine does not turn and travels straight a Brake on side which is pulled has no effect When brake pedal is depressed, machine does not stop l Defective brake adjustment a Defective brake band a Adjust a Check, repair Track comes off a Track too loose or too tight a Adjust tension a Adjust tension Abnormal wear of sprocket l Track too loose or too tight Blade rises slowly or does not rise at all (or blade tilt speed is slow) a Lack of hydraulic oil a Add oil to specified level Steering lever is heavy a Defective adjustment of play a Defective actuation of control valve o Lack of oil a Adjust o Add oil to specified level Ripper operation is slow (D85A,E only) a Lack of hydraulic oil l Add oil to specified level Ripper lacks power a Leakage of oil from piping a Tighten (D85A, E only) 2-81