Komatsu — 16.4 OTHER TROUBLE

16.

TROUBLESHOOTING 16.4.3 ENGINE Engine oil pressure caution Problem l Engine oil pan oil level is low (sucking in air) Main causes l Add oil to specified level, see CHECK BEFORE STARTING a Replace cartridge, see EVERY 250 HOURS SERVICE Remedy lamp remains alight when engine speed is raised after l Clogged oil filter cartridge completion of warm-up l Defective tightening of oil pipe joint, oil leakage from damaged lo Check, repair) part l Defective caution lamp (o Replace lamp) Steam is emitted from top part of radiator (pressure valve) Cooling water level low, water leakage Loose fan belt a Add cooling water, repair, see CHECK BEFORE STARTING l Adjust fan belt tension, see EVERY 250 HOURS SERVICE Dirt or scale accumulated in cooling system Clogged radiator fin or damaged l Change cooling water, clean inside of cooling system, see WHEN REQUIRED l Clean or repair, see WHEN REQUIRED fin Defective thermostat Loose radiator filler cap (high (o Replace thermostat) a Tighten cap or replace packing gauge is in red range Indicator of water temperature altitude operation) Defective water temperature gauge (o Replace water temperature gauge) Indicator of water temperature gauge is in white range l Defective thermostat (o Replace thermostat) (o Replace water temperature gauge) l Defective water temperature gauge Engine does not start when starting motor is turned Lack of fuel l Add fuel, see CHECK BEFORE Air in fuel system Defective fuel injection pump or STARTING a Repair place where air is sucked in nozzle Starting motor cranks engine (o Replace pump or nozzle) k See ELECTRICAL SYSTEM sluggishly Glow signal does not glow red Defective compression o Defective valve clearance (o Adjust valve clearance) Exhaust gas is white or blue l Too much oil in oil pan l Add oil to specified level, see CHECK l Improper fuel l Change to specified fuel BEFORE STARTING Exhaust gas occasionally turns a Clogged air cleaner element l Clean or replace, see WHEN REQUIRED black a Defective nozzle a Defective compression :o Replace nozzle) :o Adjust valve clearance) Combustion noise occasionally l Defective nozzle 10 Replace nozzle) Abnormal noise generated (combustion or mechanical) makes breathing sound a Low grade fuel being used b Change to specified fuel B See item “Indicator of water temperature gauge is in red range on right side of l Overheating l Damage inside muffler gauge”.

IO Replace muffler) a Excessive valve clearance IO Adjust valve clearance) 2-82