Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE Loosen nut @ and remove bolt 0, then replace or turn over. 1) Install the edge to the blade and tighten temporarily, then push the blade against the ground surface to remove any play in bolt 0, and tighten to the specified tightening torque. After several hours of running, retighten the nuts. f 5 2) When installing end bit 0, bring top surface @ of the end bit into tight contact with stopper 0, then tighten the bolts. 000 G 6. 00 0 i I O’/l 0 4 AE111600 3-29