24. SERVICE PROCEDURE 24.2.7 REPLACING RIPPER POINT, PROTECTOR A WARNING It is extremely dangerous if the work equipment moves during the replacement operation. Set the work equipment in a stable condition, stop the engine, then lock the ripper controller lever securely with the safety lock. Replace the ripper point and protector before they exceed the wear limit. 1. Raise the ripper to a suitable height, then put a block under the ripper to prevent it from coming down. Push the safety lock to set to the LOCK position. 2. Measure the wear of the ripper point and protector according to the following wear standards. Wear standards Unit:
mm (in) Item Standard dimension Repair limit Judgement standard No. Measurement point 1 Point 335 (13.2) 225 (8.9) 2 I Protector If the part is worn, replace it with a new part, AE111610 3. Using a hammer, remove the point or protector mounting pin in the direction shown by the arrow, then clean the mounting surface. 4. Install the new point or protector. If the mounting pin is damaged, replace it at the same time. 3-30