Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.8 ADJUSTING BRAKE PEDAL if the travel of the brake pedal is too large, the brake lining is probably worn, so adjust as follows. ADJUSTMENT METHOD Adjust both the left and right brakes. Remove the cover at the rear of the fender, then remove brake inspection cover 0. Tighten adjustment bolt @ (tightening torque: 49 Nm (5 kgm, 36 Ibft)) to bring the lining into tight contact with the drum. Turn adjustment bolt @ back approx. 1 - l/6 turn. Depress the brake pedal and check that the brake travel is within the standard value. Engine stopped: 75 mm (2.96 in) Engine at idling:

110 - 130 mm (4.33 - 5.12 in) NOTICE Adjust so the travel of the left and right pedals is the same. If there is a difference, the brakes will pull to one side. 5. Measure dimension A of the brake adjustment bolt, and if it is less than 71 mm (2.80 in), replace the lining. I AE111630 If the braking effect is still poor even after adjusting, please contact your Komatsu distributor for repairs. AE111640 3-31