24. SERVICE PROCEDURE 24.2.9 ADJUSTING IDLER CLEARANCE The idler moves forward and backwards under external force. When this happens, the side guide and top and bottom guide plates will wear. If these parts are worn too much, the idler will move to the side or be at an angle, and the track may come off or wear unevenly. To prevent this, adjust as follows. ADJUSTING IN SIDEWAYS DIRECTIONS 1. Drive the machine for 1 - 2 m on flat ground, then measure clearance A (left, right, inside, and outside: 4 places) between the track frame and guide plates. I I 2.
If clearance A is more than 4 mm (0.16 in), loosen bolt @ and remove shim @to adjust the clearance on one side to 0.5 - 1 mm (0.02 - 0.04 in). There are two thicknesses of shim: 0.5 mm (0.02 in), 1 .O mm (0.04 in). When loosening bolt 0, do not loosen it more than 3 turns. AE111660 3-32