24. SERVICE PROCEDURE 24.4.4 CHECK LEVEL OF BAlTERY ELECTROLYTE Carry out this check before operating the machine. a WARNING l To avoid gas explosions, do not bring fire or sparks near the l Battery electrolyte is dangerous. If it gets in your eyes or on your skin, wash it off with large amounts of water, and consult a doctor. 1. Open the cover at the rear of the operator’s compartment. 2. Remove cap 0, and check that the electrolyte is at the specified level (IO to 12 mm (0.39 to 0.47 in) above the plate). If the electrolyte level is low, add distilled water to the specified level. If the battery electrolyte is spilled, have dilute sulphuric acid added. 3.
Clean the air hole in the battery cap, then tighten the cap securely. NOTICE When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from freezing. 3-42