Komatsu — 24.4 EVERY 250 HOURS SERVICE

24.4.5 CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST Checking The belt should normally deflect by 15 mm (0.59 in) when pressed with the finger (with a force of approx. 6 kg (13.2 lb)) at a point midway between the alternator pulley and drive pulley. AE111830 Alternator Dullev . , Drive pulley AE111840 Adjusting 1. Loosen bolts nuts @ and 0. 2. Measure the deflection at the center of the belt when it is pushed with a force of approx. 6 kg (13.2 lb). Deflection more than 15 mm (0.59 in) + increase belt tension Deflection less than 15 mm (0.59 in) + loosen belt tension 3. When loosening the belt, loosen nut @ and adjust so that the deflection of the belt is approx. 15 mm (0.59 in) (at approx.

6 kg (13.2 lb)). After adjusting, tighten nut 0. 4. When increasing the belt tension, loosen nut 0, and adjust with nut @ so that the belt deflection is approx. 15 mm (0.59 in) (at approx. 6 kg (13.2 lb)). After adjusting, tighten nut 0. 5. Tighten the bolts @ and @ to fix alternator @ in position. 6. Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 7. If the V-belt is elongated and cannot be adjusted any further, or if there are any cuts or cracks, replace the V-belt. 8. When the new belt is set, readjust it after operation for an hour. 3-43