24. SERVICE PROCEDURE 24.5 EVERY 500 HOURS SERVICE Maintenance for every 250 hours service should be carried out at the same time. 24.5.1 REPLACE FUEL FILTER CARTRIDGE l Do not bring fire or sparks near the fuel. Prepare a filter wrench and a container to catch the fuel. Set the container to catch the fuel under the filter cartridge. 1. 2. Remove drain plug @ at the bottom of the filter, and drain the oil. 3. Using a filter wrench, turn filter cartridge @counterclockwise to remove it. 4. Clean the filter holder, fill a new filter cartridge with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. 5.
When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it up l/2 to 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. 6. After replacing filter cartridge 0, loosen air bleed plug 0. 7. Loosen the knob of feed pump 0, then operate it up and down until no more bubbles come out with the fuel from air bleed plug 0. 8. Tighten air bleed plug 0, then push in the knob of feed pump @ and tighten it. 9.
After replacing the filter cartridge, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is any leakage of fuel, check the tightening of the filter cartridge. Whenever there is leakage of fuel, follow Steps 1 - 3 to remove the filter cartridge, then check the packing surface for damage or foreign material. If any damage or foreign material is found in the packing, replace the packing with a new part, then repeat Steps 4 - 9 to install the filter cartridge. 3-45