11. EXPLANATION OF COMPONENTS Replacing point and protector If the point and protector installed to the tip to protect the shank are worn, replace them. Using a hammer and punch against the point marked by the arrow, knock out and remove from the opposite side. The pin is a unitized type, so insert the pin partially by hand, then knock it in fully with a hammer. Reversing point To improve the cutting power of the point and to use it effec- tively, turn the point every time the wear reaches approx. 30 mm (1.18 in). AE110410 11.5 DUST INDICATOR This device indicates clogging of the air cleaner element. When the red piston appears in transparent part @ of this indicator, the element is clogged.
Clean the element immediately. After cleaning, push indicator button @ to return the red piston to its original position. The dust indicator is on the air cleaner bracket inside the engine room. 11.6 DOOR LOCK This lock is used to lock the door in position when it is opened. 1. When the door is forced against catcher 0, the door will be locked in position. AE081830 2. To release the door, push knob @I above the catcher. The catcher will unlock the door. NOTICE When locking the door in positon, be sure to force it firmly against the catcher. AE104920 2-22