Komatsu — 11.4 CONTROL LEVERS, PEDALS

11. EXPLANATION OF COMPONENTS 11. SAFETY LOCK (FOR RIPPER CONTROL LEVER)(FOR D85A, E) IA WARNINGI When leaving the operator’s compartment, set the safety lock securely to the LOCK position. If the control lever is not locked, and it is touched by mistake, this may lead to a serious accident. If the safety lock is not placed securely in the LOCK position, the control lever may not be properly locked. Check that the situation is as shown in the diagram. When parking or servicing the machine, be sure to lower the ripper and set the safety lock in the LOCK position. AE110380 This device is used to lock the ripper control lever.

Method of releasing pressure in work equipment circuit Lower the work equipment and stop the engine. After stopping the engine, operate the work equipment control lever fully to the front, rear, left, and right to release the pressure inside the work equipment circuit. 0 1. 2. Adjusting digging depth There are two mounting pin holes in the shank and these are used according to the digging depth. For normal use, use the bottom hole; when deep dipping is required, use the top hole. When changing the digging depth, use a hammer and punch at pin @ on either the left or right, knock out and remove from the opposite side. Next, remove pin 0, then change the shank hole position (top or bottom).

The pin is a unitized type, so insert the pin partially by hand, then knock it in fully with a hammer. 2-21