11. EXPLANATION OF COMPONENTS 9. BLADE CONTROL LEVER This lever is used to raise or tilt the blade. Lifting control @ RAISE : (K, @ HOLD : (b, Blade is stopped and held in this position. @ LOWER : ( ’ ) % @ FLOAT : (_) Blade will move freely according to external force. REMARK When released from FLOAT position, this lever will not return to HOLD position, so it must be moved back by hand. Raise u a Lower &= AE110340 Tilting control @ LEFT TILT : (J&J @ RIGHT TILT : (&, NOTICE l The lever should be returned quickly to HOLD position at the end of tilt cylinder stroke. l Do not operate tilting when blade is at top or bottom position.
l After stopping the engine, if the blade control lever is operated to the LOWER position, the work equipment will go down under its own weight. I AE110350 1 10. RIPPER CONTROL LEVER (FOR D85A, E) This is used to operate the ripper. RAISE (9) HOLD ( 7 1: Ripper is stopped and held in the same position. LOWER( 71) i NOTICE After stopping the engine if the ripper control lever is operated to the LOWER position, the work equipment will go down under its own weight. AE110370 2-20