Komatsu — 12.9 PRECAUTIONS FOR OPERATION

12.9 PRECAUTIONS FOR OPERATION 12.9.1 PAY ATTENTION TO GAUGES When the red range lights on the power train oil temperature gauge while operating, reduce load and wait for lowering of tem- perature. 12.9.2 METHOD OF USING STEERING CLUTCH If the steering clutch one side is used frequently or if many gradual turns are made with steering clutch half-engaged, the steer- ing clutch will wear out in a short time. Design the travel road well and steer the machine properly. 12.9.3 PERMISSIBLE WATER DEPTH When working in water, operate the machine only within a depth where the center of the idler remains above the water surface. If the cooling fan goes into the water, the fan may break.

12.9.4 PRECAUTIONS WHEN TRAVELING UP OR DOWN HILLS AE201040 METHOD OF USING DECELERATOR PEDAL If the decelerator pedal is depressed when traveling uphill, the engine speed will drop and the gradeability will be reduced. For this reason, the machine may stop and the engine may also stall. If the engine stops, the braking effect will be reduced, so be careful not to let the engine stop when the decelerator pedal is depressed. If the decelerator pedal is depressed too much and the machine stops, depress the brake pedal before the engine stops in order to apply the brake securely and hold the machine.

USE ENGINE AS A BRAKE When traveling downhill, set the gear shift lever to low speed, run the engine at low speed, and use the engine as a brake. Never go down hills with the gear shift lever at Neutral. BRAKING WHEN TRAVELING DOWNHILL When using the engine as a brake during downhill travel, use the service brake also. Using only the braking force of the engine may cause the engine to overrun. In particular, when traveling downhill towing a scraper, if the transmission is shifted down, the engine will tend to overrun, so do not shift down while traveling downhill. 2-56