SAFETY RULES FOR ROAD TRAVEL Traveling with your machine may pose some hazards. When traveling, always travel in a safe manor and remain alert at all times A safety conscious operator is the most important insurance when traveling with the machine. Below are several situations and information the operator should be aware of: When traveling on level ground, pull in the work equipment and keep it at a height of 40 to 50 cm (16 to 20 in) from the ground. When traveling on rough ground, travel at low speed and do not operate the steering suddenly since there is a danger that the machine may turn over.
Also, be careful that the work equipment does not hit the ground surface and cause the machine to lose balance, damage the machine or other structures in the area. Always turn the auto-deceleration switch OFF (cancel) (if equipped) when traveling on rough ground or steep slopes. If the auto-deceleration is ON, the engine speed may accelerate and the travel speed may suddenly increase. Avoid traveling over obstacles or raised ground when possible. If the machine has to travel over an obstacle or uneven area, keep the work equipment close to the ground and travel at low speed. Never travel over obstacles which make the machine tilt sharply to one side.
When traveling, always maintain a safe distance from people, structures, or other machines to avoid coming into contact with them. Check to be sure that bridges and structures are strong enough to support the weight of the machine before passing over them. When traveling on public roads, check with the relevant authorities and follow their instructions. When traveling in tunnels, under bridges, under electric wires, or other places with limited height, operate slowly and be extremely careful not to let the work equipment hit anything. Traveling with Carriage Reversed Traveling with the carriage reversed may pose several hazards, although not recommended.
Below is a list if some basic rules to follow when traveling in reverse: Be aware that the travel controls will be working in the opposite direction. Before moving your machine check each control lever to verify its travel directional position. When operating in areas that may pose a hazard or has poor visibility, you may want to travel with the carriage in the normal position. PC350LL-7E0 1-31