SAFETY Travel on Slopes Traveling on slopes may pose a hazard. In order to prevent tipping the machine or losing control it is important to follow some basic simple rules: Never turn the ignition key off when traveling up or down a slope. If the engine should stop, lower the work equipment to the ground immediately. Keep the work equipment approximately 20 to 30 cm (8 to 12 in) above the ground. In case of emergency, immediately lower the work equipment to the ground to help stop the machine. Face the operators cab uphill when traveling up slopes. When traveling down slopes, set the operator's cab facing downhill. Always check the firmness of the ground before traveling.
When traveling up a steep slope, extend the work equipment to the front to improve the balance. Keep the work equipment approximately 20 to 30 cm (8 to 12 in) above the ground, and travel at low speed. When traveling downhill, lower the engine speed, keep the travel at a low speed. Always travel straight up or straight down a slope, traveling at an angle on a slope may cause the machine to tip or possibly rollover. Never turn on a slope, doing so may cause the machine to tip or rollover. Be extra cautious when traveling on grass or fallen leaves especially on a slope these hazards may cause the machine to slip. 1-32 PC350LL-7E0