PERIODIC SERVICE 84 B Checking Engine Oil Level To avoid personal injury: A Be sure to stop the engine before checking the oil level. A Do not permit dirt or trash to get into the fuel system. A Be careful not to let the fuel tank become empty, otherwise air will enter the fuel system, necessitating bleeding before next engine start. A Be careful not to spill during refueling. If should spill, wipe it off at once, or it may cause a fire. A To prevent condensation (water) accumulation in the fuel tank, fill the tank before parking overnight. 1. Park the machine on a flat surface. 2. Check engine oil before starting the engine or 5 minutes or more after the engine has stopped. 3.
To check the oil level, draw out the dipstick, wipe it clean, replace it, and draw it out again. Check to see that the oil level lies between the two notches. If the level is too low, add new oil to the prescribed level at the oil inlet. (See "LUBRICANTS" in "MAINTENANCE" section.) A No.2-D is a distillate fuel of lower volatility for engines in industrial and heavy mobile service. (SAE J313 JUN87) A Grade of Diesel Fuel Oil According to ASTM D975 (1) Oil inlet (2) Dipstick (A) Oil level is acceptable within this range. A When using an oil of different maker or viscosity from the previous one, remove all of the old oil. Never mix two different types of oil.
A If oil level is low, do not run engine. uel tank apacity L3240, L3540 L3940, L4240 L4740, L5040, L5240, L5740 44L (11.6 U.S.gals.) 50 L (13.2 U.S.gals.) 54 L (14.3 U.S.gals.) Flash Poi ( Water and nt, Sediment, ) volume % Carbon Residue on, 10 percent Residuum, % Ash, weight % Min Max Max Max 52 (125 ) 0.05 0.35 0.01 Distillatio Tempera tures, ( ) 90% Poi n Viscosity - Kinematic cSt or mm /s nt at 40 Viscosity Saybolt, SUS at 100 Sulfur weight % Cop- per Strip Corro- sion Ce- tane Num- ber Min M ax Min Max Min Max Max Max Min 82 3 40) (6 38 1.9 40) 4.1 32.6 40.1 0.50 No.3 40