85 PERIODIC SERVICE B Checking Transmission Fluid Level 1. Park the machine on a flat surface, lower the implement and shut off engine. 2. To check the oil level, draw out the dipstick, wipe it clean, replace it, and draw it out again. Check to see that the oil level lies between the two notches. If the level is too low, add new oil to the prescribed level at the oil inlet. (See "LUBRICANTS" in "MAINTENANCE" section.) [ROPS Type] [CAB Type] (1) Gauge (2) Oil inlet (A) Oil level is acceptable within this range. A If oil level is low, do not run engine. B Checking Coolant Level (1) Recovery tank (A) "FULL" (B) "LOW" To avoid personal injury: A Do not remove radiator cap while coolant is hot.
When cool, slowly rotate cap to the first stop and allow sufficient time for excess pressure to escape before removing the cap completely. A If the radiator cap has to be removed, follow the caution above and securely retighten the cap. A Use clean, fresh soft water and anti-freeze to fill the recovery tank. A If water should leak, consult your local KUBOTA Dealer. 1. Check to see that the coolant level is between the "FULL" and "LOW" marks of recovery tank. 2. When the coolant level drops due to evaporation, add soft water only up to the full level. In case of leakage, add anti-freeze and soft water in the specified mixing ratio up to the full level.
(See "Flushing Cooling System and Changing Coolant" in "EVERY 2 YEARS" in "PERIODIC SERVICE" section.)