PERIODIC SERVICE 90 EVERY 100 HOURS B Cleaning Air Cleaner Primary Element 1. Remove the air cleaner cover and primary element. 2. Clean the primary element: (1) When dry dust adheres to the element, blow compressed air from the inside, turning the element. Pressure of compressed air must be under 205 kPa (2.1 kgf/cm , 30 psi). (2) When carbon or oil adheres to the element, soak the element in detergent for 15 minutes then wash it several times in water, rinse with clean water and dry it naturally. After element is fully dried, inspect inside of the element with a light and check if it is damaged or not. 3. Replace air cleaner primary element:
Once yearly or after every sixth cleaning, whichever comes first. B Cleaning Fuel Filter This job should not be done in the field, but in a clean place. 1. Close the fuel cock. 2. Unscrew the screw ring and remove the filter bowl, and rinse the inside with kerosene. 3. Take out the element and dip it in the kerosene to rinse. 4. After cleaning, reassemble the fuel filter, keeping out dust and dirt. 5. Bleed the fuel system. (See "Bleeding Fuel System" in "SERVICE AS REQUIRED" in "PERIODIC SERVICE" section.) A Check to see if the evacuator valve is blocked with dust.
(1) Fuel cock (2) Fuel filter bowl (A) "CLOSE" (1) Secondary (safety) element (2) Primary element (3) Cover (4) Evacuator valve A The air cleaner uses a dry element, never apply oil. A Do not run the engine with filter element removed. A Be sure to refit the cover with the arrow (on the rear of cover) upright. If the cover is improperly fitted, evacuator valve will not function and dust will adhere to the element. A Do not touch the secondary element except in cases where replacing is required.
(See "Replacing Air Cleaner Secondary Element" in "EVERY 1 YEAR" in "PERIODIC SERVICE" section.) (1) O ring (2) Filter element (3) Spring (4) Filter bowl (5) Screw ring C Evacuator Valve Open the evacuator valve once a week under ordinary conditions - or daily when used in a dusty place - to get rid of large particles of dust and dirt. A If dust and dirt enters the fuel system, the fuel pump and injection nozzles are subject to premature wear. To prevent this, be sure to clean the fuel filter bowl and element periodically.