91 PERIODIC SERVICE B Adjusting Fan Belt Tension B Checking Fuel Line 1. Check to see that all lines and hose clamps are tight and not damaged. 2. If hoses and clamps are found worn or damaged, replace or repair them at once. To avoid personal injury: A Be sure to stop the engine before checking belt tension. 1. Stop the engine and remove the key. 2. Apply moderate thumb pressure to belt between pulleys. 3. If tension is incorrect, loosen the alternator mounting bolts and, using a lever placed between the alternator and the engine block, pull the alternator out until the deflection of the belt falls within acceptable limits. 4. Replace fan belt if it is damaged.
(1) Fuel lines (2) Clamp bands A If the fuel line is removed, be sure to properly bleed the fuel system. (See "Bleeding Fuel System" in "SERVICE AS REQUIRED" in "PERIODIC SERVICE" section.) (1) Bolt (A) Check the belt tension (B) To tighten Proper fan belt tension A deflection of between 7 to 9 mm (0.28 to 0.34 in.) when the belt is pressed in the middle of the span.