Kubota L3240, L3540, L3940, L4240, L4740, L5040, L5240, L5740 — Changing Transmission Fluid / Replacing Hydraulic Oil Filter

99 PERIODIC SERVICE EVERY 400 HOURS B Changing Transmission Fluid / Replacing Hydraulic Oil Filter To avoid personal injury: A Be sure to stop the engine before changing the oil filter cartridge. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. Remove the drain plugs at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining reinstall the drain plugs. 3. Remove the oil filter. (1) Drain plugs (1) Drain plugs (1) Hydraulic oil filter 4. Put a film of clean transmission oil on the rubber seal of the new filter. 5.

Quickly tighten the filter until it contacts the mounting surface, then tighten it by hand an additional 1/2 turn only. 6. Fill with the new KUBOTA SUPER UDT fluid up to the upper notch on the dipstick. (See "LUBRICANTS" in "MAINTENANCE" section.) (1) Drain plug Oil Capacity L3240, L3540 42 L (11.1 U.S.gals.) L3940, L4240, L4740 43 L (11.4 U.S.gals.) L5040, L5240, L5740 45 L (11.9 U.S.gals.)