Kubota L3240, L3540, L3940, L4240, L4740, L5040, L5240, L5740 — Lubricating Grease Fitting - 2WD

PERIODIC SERVICE 100 (1) Gauge (2) Oil inlet (A) Oil level is acceptable within this range. 7. After running the engine for a few minutes, stop the engine and check the oil level again, add oil to the prescribed level. 8. Make sure that the transmission fluid doesn't leak past the seal on the filter. (1) Check plug (2) Filling plug (3) Drain plug A To prevent serious damage to the hydraulic system, use only a KUBOTA genuine filter. A Do not operate the tractor immediately after changing the transmission fluid. Run the engine at medium speed for a few minutes to prevent damage to the transmission.

B Replacing Fuel Filter Element (See "Cleaning Fuel Filter" in "EVERY 100 HOURS" in "PERIODIC SERVICE" section.) B Changing Front Axle Case Oil 1. To drain the used oil, remove the right and left drain plugs and filling plug at the front axle case and let out the oil completely into the oil pan. 2. After draining, reinstall the drain plugs. 3. Gently pour new oil through the filling port. Required oil quantities are written in the table below. Make sure to pour the specified amounts. If oil overflows before pouring any of the specified amounts, wait a couple of minutes and try again. (See "LUBRICANTS" in "MAINTENANCE" section.) 4. After filling, reinstall the filling plug. 5.

Run the vehicle a few minutes in order for the oil to flow through the font axle case. 6. Remove the oil level check plug and check to see if the oil flows out of its port. If not, add the oil through the filling port until it flows out of the oil level check port. 7. Reinstall and tighten the oil level check plug and filling plug. B Lubricating Grease Fitting [2WD] Detach the cover, and apply grease. (1) Front wheel hub cover Oil capacity L3240, L3540, L3940 6.5 L (6.9 U.S.qts.) L4240, L4740, L5040, L5240, L5740 8.5 L (8.9 U.S.qts.)