OPERATING THE TRACTOR 52 CHECK DURING DRIVING B Immediately Stop the Engine if: A The engine suddenly slows down or accelerates, A Unusual noises are suddenly heard, A Exhaust fumes suddenly become very dark, B IntelliPanel(TM) Message If any of the following messages appears during operation, immediately stop the machine and follow the message's instructions. If the cause of trouble has not been pinpointed, consult your local KUBOTA Dealer. B Easy Checker(TM) If the indicators in the Easy Checker(TM) come on during operation, immediately stop the engine, and find the cause as shown below. Never operate the tractor while Easy Checker(TM) lamp is on.
C Engine over heat If the engine gets overheated, the lamp on the meter panel lights up and the following messages appear alternately. 1. Stop operation and set the engine to the idling speed. 2. When the coolant temperature has dropped, the following messages appear instead. Engine oil pressure If the oil pressure in the engine goes below the prescribed level, the indicator in the Easy Checker(TM) will come on. If this should happen during operation, and it does not go off when the engine is accelerated to more than 1000 rpm, check level of engine oil. (See "Checking Engine Oil Level" in "DAILY CHECK" in "PERIODIC SERVICE" section.) 3.
Stop the engine, wait for 30 minutes until the machine cools down, and check the following points. (1) Check the reserve tank and radiator for cooling water shortage or leak. (2) Check the insect screening and radiator for chaff and dust deposits. (3) Check the fan belt for slack. Electrical charge If the alternator is not charging the battery, the indicator in the Easy Checker(TM) will come on. If this should happen during operation, check the electrical charging system or consult your local KUBOTA Dealer. A If steam gushes out of the reserve tank's overflow pipe, take the measure discussed above.
C SERVICE INSPECT Every 50 operating hours, the "SERVICE INSPECT" message appears on the meter panel. If the HST or GST Transmission malfunctions, the indicator in the Easy Checker(TM) will blink. If this should happen during operation, carefully move the tractor to a safe place, contact your local KUBOTA Dealer for repairs. A For checking and servicing of your tractor, consult your local KUBOTA Dealer for instructions. (1) "SERVICE INSPECT" 1. Finish the job in hand, and do the routine inspection referring to the hours being displayed. (See "SERVICE INTERVALS" in "MAINTENANCE" section.) 2. Reset the "SERVICE INSPECT" message as follows.
Keep pushing both display mode button and travel speed button for two seconds or more while HOUR METER MODE.