53 OPERATING THE TRACTOR B Fuel Gauge When the key switch is on, the liquid crystal blocks indicate the fuel level. Be careful not to empty the fuel tank. Otherwise air may enter the fuel system. Should this happen, the system should be bled. (See "Bleeding Fuel System" in "SERVICE AS REQUIRED" in "PERIODIC SERVICE" section.) B Coolant Temperature Gauge To avoid personal injury: A Do not remove radiator cap until coolant temperature is well below its boiling point. Then loosen cap slightly to the stop to relieve any pressure before removing cap completely. 1. With the key switch at "ON" the liquid crystal blocks indicate the temperature of the coolant. "C" for "cold" and "H" for "hot." 2.
If the indicator reaches the "H" position, engine coolant is overheated. Check the tractor by referring to "TROUBLESHOOTING" section. (1) Fuel gauge (E) "EMPTY" (F) "FULL" A When all the liquid crystal blocks but the leftmost one of the fuel gauge go out, "FUEL" appears in the liquid crystal display. If this should happen during operation, refuel as soon as possible. (See "Checking and Refueling" in "DAILY CHECK" in "PERIODIC SERVICE" section.) (1) Coolant temperature gauge B Tachometer The tachometer indicates the engine speed. (1)Engine revolution