Kubota L3240, L3540, L3940, L4240, L4740, L5040, L5240, L5740 — Drawbar

THREE-POINT HITCH & DRAWBAR 62 3-POINT HITCH B Selecting the top link mounting holes Select the proper set of holes by referring to the "Hydraulic Control Unit Use Reference Chart" in "HYDRAULIC UNIT" section. If the hydraulic unit is set for draft control, draft response is more sensitive when an implement is connected to the upper set of top link mounting holes. If draft control is not required, it is recommended to use the low set (4). 1. Make preparations for attaching implement. B Category 1 & 2 L5040, L5240, L5740 have both category 1 & 2. Category 1 type is standard and assemble all parts shown as below. To change from category 1 to category 2. 1.

Remove adjusting collar from the lower link. 2. Remove adjusting collar from the rear top link pin. 3. Use the correct rear top link pin for category 2. [Category 1 type] B Drawbar Remove the drawbar if a close mounted implement is attached. 2. Attaching and detaching implements [Category 2 type] To avoid personal injury: A Be sure to stop the engine. A Do not stand between tractor and implement unless parking brake is applied. A Before attaching or detaching implement, locate the tractor and implement on a firm level surface. A Whenever an implement or other attachment is connected to the tractor 3-point hitch, check full range of operation for interference, binding or PTO separation.

(1) Lower link (2) Top link (3) Collar, lower link (1) (4) Top link rear pin (1) (5) Collar, top link (1) (6) Top link rear pin (2) B Category 1 L3240, L3540, L3940, L4240, L4740 have category 1 only.