63 THREE-POINT HITCH & DRAWBAR B Lifting Rod (Right) B Telescopic Stabilizers Adjust the telescopic stabilizers to control horizontal sway of the implement. Select the proper set of holes by referring to the "Hydraulic Control Unit Use Reference Chart" in "REMOTE HYDRAULIC CONTROL SYSTEM" in "HYDRAULIC UNIT" section. After aligning satisfactorily, insert the set-pin through any one of the four holes on the outer tube that align with one of the holes on the inner bar, both stabilizers will be locked. If the set-pin is inserted through the slot to engage one of the holes on the inner bar, a limited degree of sway will be permitted. To avoid personal injury:
A Do not extend lifting rod beyond the groove on the thread rod. 1. To adjust the length of the lifting rod, lift the adjusting handle and turn to desired length. 2. After adjusting, lower the lifting rod adjusting handle to the lock position. 3. When extending the rod using adjusting handle, do not exceed the groove on the rod thread. (1) Lifting rod (2) Adjusting handle (A) "GROOVE" (1) Outer tube (2) Inner bar (3) Set-pin (4) Hole (5) Slot B Telescopic Lower Links To attach an implement, follow the instructions below: 1. Push the levers, pull out the lower link ends, and attach to the implement. 2. Back up the tractor slightly to make sure the lower links are pushed in securely.
(1) Adjusting handle (2) Lock pin (A) "LOCK POSITION" (B) "UNLOCK POSITION" B Top Link 1. Adjust the angle of the implement to the desired position by shortening or lengthening the top link. 2. The proper length of the top link varies according to the type of implement being used. (1) Lever (A) "PUSH" (B) "PULL OUT"