Kubota L3240, L3540, L3940, L4240, L4740, L5040, L5240, L5740 — Swing Drawbar

THREE-POINT HITCH & DRAWBAR 64 DRAWBAR B Swing Drawbar The drawbar can be used in three different ways as illustrated below. Assemble it correctly with joint pins set To avoid personal injury: A Never pull from the top link, the rear axle or any point above the drawbar. Doing so could cause the tractor to tip over rearward causing personal injury or death. B Adjusting Drawbar Length When towing an implement, recommend use of (A) or (B) hole in drawbar. The drawbar load is referred to "IMPLEMENT LIMITATIONS" section. Holes : (C),(D) (1) PTO shaft (2) Drawbar (3) Drawbar pin Holes : (A),(B) at the points as marked by in the figure.

Hole Tractor model (C) L3240, L3540 (D) L3940, L4240, L4740, L5040, L5240, L5740 Hole Tractor model (A) L3240, L3540 (B) L3940, L4240, L4740, L5040, L5240, L5740