Kubota L3240, L3540, L3940, L4240, L4740, L5040, L5240, L5740 — Hydraulic Control Unit Use Reference Chart

70 HYDRAULIC UNIT B Hydraulic Control Unit Use Reference Chart In order to handle the hydraulics properly, the operator must be familiar with the following. Though this information may not be applicable to all types of implements and soil conditions, it is useful for general conditions.

Implement Soil condition with Position control with Draft control Gauge wheel (1) Telescopic stabilizers Remarks Top link mounting holes (1) Position control lever Top link mounting holes (1) Position control lever (2) Draft control lever Moldboard plow Light soil Medium soil Heavy soil 1 or 2 2 or 3 3 Position control 1 or 2 2 or 3 3 Draft and Mixed control Place the draft control lever to the suitable position and set the implement pull with the position control lever YES/NO Loose Insert the set-pin through the slot on the outer tube that align with one of the holes on the inner bar. For implements with gauge wheels, lower the position control lever all way.

Disc plow --- 2 or 3 2 or 3 Harrow (spike, springtooth, disc type) --- 2 or 3 2 or 3 Sub-soiler ... Weeder, ridger... --- 3 4 Position control Hold the draft control lever at the most front position during operation. YES Tighten Telescopic stabilizer should be tight enough to prevent excessive implement movement when implement is in raised position. Earthmover, digger, scraper, manure fork, rear carrier......... YES/NO Mower (mid- and rear- mount type) NO