SEBU9064 47 Refill Capacities Fluid Recommendations Engines that are manufactured by Perkins are certified with the fuel that is prescribed by the United States Environmental Protection Agency . Engines that are manufactured by Perkins are certified with the fuel that is prescribed by the European Certification. Perkins does not certify diesel engines on any other fuel. Note: The owner and the operator of the engine has the responsibility of using the fuel that is prescribed by the EPA and other appropriate regulatory agencies. NOTICE Operating with fuels that do not meet the Perkins rec- ommendations can cause the following effects:
Start- ing difficulty, poor combustion, deposits in the fuel injectors, reduced service life of the fuel system, de- posits in the combustion chamber and reduced serv- ice life of the engine. The Perkins 400F diesel engines must be operated using Ultra Low Sulfur Diesel. The sulphur content of this fuel must be lower than 15 PPM. This fuel complies with the emissions regulations that are prescribed by the Environmental Protection Agency of the United States The fuels that are listed in the table 26 are acceptable to use on all 400F engines. Table 26 (1) All the fuels must comply with the specification in the table for the Perkins Specification Distillate Diesel Fuel .
Diesel Fuel Characteristics Cetane numbers in excess of 45 are normally expected from current diesel fuel. However, a cetane number of 40 may be experienced in some territories. The United States of America is one of the territories that can have a low cetane value. A minimum cetane value of 40 is required during average starting conditions. A fuel with higher cetane number is recommended for operations at high altitudes or in cold-weather operations. Cetane Number Fuel that has a high cetane number will give a shorter ignition delay. A high cetane number will produce a better ignition quality.
Cetane numbers are derived for fuels against proportions of cetane and heptamethylnonane in the standard CFR engine. Refer to ISO 5165 for the test method. Fuel with a low cetane number can be the root cause of problems during a cold start. Acceptable Fuel Specification for the 400F Engines(1) Fuel Specification Comments EN590 European Automotive Diesel Fuel (DERV) ASDM D975 GRADE 1D S15 “North American Light Distillate Diesel fuel with less than 15 PPM sulfur level” ASTM D975 GRADE 2D S15 “North American Middle Distillate general purpose Diesel fuel with less than 15 PPM sulfur level” JIS K2204 “Japanese Diesel Fuel” Must meet the requirements that are stated in the section “Lubricity”.
BS 2869 or equivalent “EU Off Road Diesel fuel. Acceptable from 2011 MUST have less than 10 PPM sulfur level”