SEBU9064 51 Maintenance Recommendations System Pressure Release Maintenance Recommendations Components for the driven equipment should also be considered. When possible, remove the component that requires welding. When welding on an engine that is equipped with an ECM and removal of the component is not possible, the following procedure must be followed. This procedure minimizes the risk to the electronic components. i04056177 System Pressure Release 1. Stop the engine. Remove the electrical power from the ECM. Coolant System 2. Ensure that the fuel supply to the engine is turned off. 3. Disconnect the negative battery cable from the battery.
If a battery disconnect switch is installed, open the switch. Pressurized system: Hot coolant can cause seri- ous burn. To open cap, stop engine, wait until ra- diator is cool. Then loosen cap slowly to relieve the pressure. 4. Disconnect all electronic components from the wiring harnesses. Include the following components: Ensure that the power supply is isolated before any service or repair is performed. Electronic components for the driven equipment To relieve the pressure from the coolant system, turn off the engine. Allow the cooling system pressure cap to cool. Remove the cooling system pressure cap slowly in order to relieve pressure.
ECM Sensors Fuel System Relays To relieve the pressure from the fuel system, turn off the engine. NOTICE Do not use electrical components (ECM or ECM sen- sors) or electronic component grounding points for grounding the welder. Engine Oil To relieve pressure from the lubricating system, turn off the engine. i05341018 Welding on Engines with Electronic Controls Correct welding procedures are necessary in order to avoid damage to the following components: Electronic Control Module (ECM) on the engine Clean Emissions Module (CEM) Sensors Associated components