Perkins — Perkins 402F-05, 403F-07, 403F-11, 403F-15 Industrial Engines Operation and Maintenance Manual

58 SEBU9064 Maintenance Recommendations Coolant (Commercial Heavy-Duty) - Change i05336023 Coolant (Commercial Heavy- Duty) - Change 1. Stop the engine and allow the engine to cool. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap. NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to Local regulations and mandates.

NOTICE Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. Clean the cooling system and flush the cooling system before the recommended maintenance interval if the following conditions exist: Illustration 30 g03380650 Typical example The engine overheats frequently. 2. Open the drain cock or remove the drain plug (1) Foaming is observed. on the engine. Open the drain cock or remove the drain plug on the radiator. The oil has entered the cooling system and the coolant is contaminated. Allow the coolant to drain. The fuel has entered the cooling system and the coolant is contaminated. NOTICE Dispose of used engine coolant or recycle.

Various methods have been proposed to reclaim used coolant for reuse in engine cooling systems. The full distilla- tion procedure is the only method acceptable by Per- kins to reclaim the coolant. Note: When the cooling system is cleaned, only clean water is needed. Note: Inspect the water pump and the water temperature regulator after the cooling system has been drained. This is a good opportunity to replace the water pump, the water temperature regulator, and the hoses, if necessary. For information regarding the disposal and the recycling of used coolant, consult your Perkins dealer or your Perkins distributor. Drain Flush 1.

Flush the cooling system with clean water in order to remove any debris. Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. 2. Close the drain cock or install the drain plug in the engine. Close the drain cock or install the drain plug on the radiator.