Perkins — Perkins 402F-05, 403F-07, 403F-11, 403F-15 Industrial Engines Operation and Maintenance Manual

SEBU9064 57 Maintenance Recommendations Battery - Replace 4. Install new belt (5) and adjust the alternator to the required tension. Note: Always recycle a battery. Never discard a battery. Dispose of used batteries to an appropriate recycling facility. 5. Remove the used battery. 5. Tighten bolt (1) and tighten bolt and nut (2). Tighten bolt (3). Tighten all bolts and nuts to a torque of 25 N·m (221 lb in). 6. Install the new battery. Refer to this Operation and Maintenance Manual, “Alternator and Fan Belts - Inspect/Adjust” for the tension of the belt. Note: Before the cables are connected, ensure that the engine start switch is OFF. 7.

Connect the cable from the starting motor to the POSITIVE + battery terminal. i02322315 Battery - Replace 8. Connect the NEGATIVE - cable to the NEGATIVE - battery terminal. i02747977 Battery Electrolyte Level - Check Batteries give off combustible gases which can explode. A spark can cause the combustible gases to ignite. This can result in severe personal injury or death. When the engine is not run for long periods of time or when the engine is run for short periods, the batteries may not fully recharge. Ensure a full charge in order to help prevent the battery from freezing. If batteries are correctly charged, the ammeter reading should be very near zero, when the engine is in operation.

Ensure proper ventilation for batteries that are in an enclosure. Follow the proper procedures in or- der to help prevent electrical arcs and/or sparks near batteries. Do not smoke when batteries are serviced. All lead-acid batteries contain sulfuric acid which can burn the skin and clothing. Always wear a face shield and protective clothing when working on or near batteries. The battery cables or the batteries should not be removed with the battery cover in place. The bat- tery cover should be removed before any servic- ing is attempted. Removing the battery cables or the batteries with the cover in place may cause a battery explosion resulting in personal injury. 1. Remove the filler caps.

Maintain the electrolyte level to the FULL mark on the battery. If the addition of water is necessary, use distilled water. If distilled water is not available use clean water that is low in minerals. Do not use artificially softened water. 1. Switch the engine to the OFF position. Remove all electrical loads. 2. Turn off any battery chargers. Disconnect any battery chargers. 2. Check the condition of the electrolyte with a suitable battery tester. 3. The NEGATIVE - cable connects the NEGATIVE - battery terminal to the NEGATIVE - terminal on the starting motor. Disconnect the cable from the NEGATIVE - battery terminal. 3. Install the caps. 4. Keep the batteries clean.

Clean the battery case with one of the following cleaning solutions: 4. The POSITIVE + cable connects the POSITIVE + battery terminal to the POSITIVE + terminal on the starting motor. Disconnect the cable from the POSITIVE + battery terminal. Use a solution of 0.1 kg (0.2 lb) baking soda and 1 L (1 qt) of clean water. Use a solution of ammonium hydroxide . Thoroughly rinse the battery case with clean water.