60 SEBU9064 Maintenance Recommendations Coolant (ELC) - Change Note: Inspect the water pump and the water temperature regulator after the cooling system has been drained. This is a good opportunity to replace the water pump, the water temperature regulator, and the hoses, if necessary. For information regarding the disposal and the recycling of used coolant, consult your Perkins dealer or your Perkins distributor. Flush Drain 1. Flush the cooling system with clean water in order to remove any debris. 2. Close the drain cock or install the drain plug in the engine. Close the drain cock or install the drain plug on the radiator. Pressurized System: Hot coolant can cause seri- ous burns.
To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. NOTICE Do not fill the cooling system faster than 5 L (1.3 US gal) per minute to avoid air locks. Cooling system air locks may result in engine damage. 1. Stop the engine and allow the engine to cool. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap. 3. Fill the cooling system with clean water. Install the cooling system filler cap. 4. Start and run the engine at low idle until the temperature reaches 49 to 66 °C (120 to 150 °F). 5.
Stop the engine and allow the engine to cool. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap. Open the drain cock or remove the drain plug on the engine. Open the drain cock or remove the drain plug on the radiator. Allow the water to drain. Flush the cooling system with clean water. Fill 1. Close the drain cock or install the drain plug on the engine. Close the drain cock or install the drain plug on the radiator. Illustration 31 g03380650 Typical example NOTICE Do not fill the cooling system faster than 5 L (1.3 US gal) per minute to avoid air locks. 2.
Open the drain cock or remove the drain plug (1) Cooling system air locks may result in engine damage. on the engine. Open the drain cock or remove the drain plug on the radiator. Allow the coolant to drain. 2. Fill the cooling system with Extended Life Coolant (ELC). Refer to the Operation and Maintenance Manual, “Fluid Recommendations” topic (Maintenance Section) for more information on cooling system specifications. Do not install the cooling system filler cap. NOTICE Dispose of used engine coolant or recycle. Various methods have been proposed to reclaim used coolant for reuse in engine cooling systems.
The full distilla- tion procedure is the only method acceptable by Per- kins to reclaim the coolant.