Perkins — Perkins 402F-05, 403F-07, 403F-11, 403F-15 Industrial Engines Operation and Maintenance Manual

SEBU9064 61 Maintenance Recommendations Coolant Level - Check 3. Start and run the engine at low idle. Increase the engine rpm to high idle. Run the engine at high idle for 1 minute in order to purge the air from the cavities of the engine block. Stop the engine. Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. 4. Check the coolant level. Maintain the coolant level within 13 mm (0.5 inch) below the bottom of the pipe for filling.

Maintain the coolant level in the expansion bottle (if equipped) at the correct level. 5. Clean the cooling system filler cap. Inspect the gasket that is on the cooling system filler cap. If the gasket that is on the cooling system filler cap is damaged, discard the old cooling system filler cap and install a new cooling system filler cap. If the gasket that is on the cooling system filler cap is not damaged, use a suitable pressurizing pump in order to pressure test the cooling system filler cap. The correct pressure for the cooling system filler cap is stamped on the face of the cooling system filler cap.

If the cooling system filler cap does not retain the correct pressure, install a new cooling system filler cap. 2. Loosen filler cap slowly in order to relieve any pressure. Remove the filler cap. 3. Pour the correct coolant mixture into the tank. Refer to the Operation and Maintenance Manual, “Refill Capacities and Recommendations” for information on the correct mixture and type of coolant. Refer to the Operation and Maintenance Manual, “Refill Capacities and Recommendations” for the engine cooling system capacity. Do not fill the coolant recovery tank above COLD FULL mark. 6. Start the engine. Inspect the cooling system for leaks and for correct operating temperature.

i05149389 Coolant Level - Check Engines With a Coolant Recovery Tank Note: The cooling system may not have been provided by Perkins . The procedure that follows is for typical cooling systems. Refer to the OEM information for the correct procedures. Check the coolant level when the engine is stopped and cool. Illustration 32 g02590196 Filler cap NOTICE When any servicing or repair of the engine cooling system is performed, the procedure must be per- formed with the engine on level ground. Level ground will allow you to check accurately the coolant level. This checking will also help in avoiding the risk of in- troducing an air lock into the coolant system. 4.

Clean the filler cap and the receptacle. Reinstall the filler cap and inspect the cooling system for leaks. Note: The coolant will expand as the coolant heats up during normal engine operation. The additional volume will be forced into the coolant recovery tank during engine operation. When the engine is stopped and cool, the coolant will return to the engine. 1. Observe the coolant level in the coolant recovery tank. Maintain the coolant level to COLD FULL mark on the coolant recovery tank.