62 SEBU9064 Maintenance Recommendations Coolant Temperature Regulator - Replace Engines Without a Coolant Recovery Tank i05160120 Coolant Temperature Regulator - Replace Check the coolant level when the engine is stopped and cool. Replace the water temperature regulator before the water temperature regulator fails. This is a recommended preventive maintenance practice. Replacing the water temperature regulator reduces the chances for unscheduled downtime. A water temperature regulator that fails in a partially opened position can cause overheating or overcooling of the engine. A water temperature regulator that fails in the closed position can cause excessive overheating.
Excessive overheating could result in cracking of the cylinder head or piston seizure problems. Illustration 33 g00285520 Cooling system filler cap A water temperature regulator that fails in the open position will cause the engine operating temperature to be too low during partial load operation. Low engine operating temperatures during partial loads could cause an excessive carbon buildup inside the cylinders. This excessive carbon buildup could result in an accelerated wear of the piston rings and wear of the cylinder liner. Pressurized System: Hot coolant can cause seri- ous burns.
To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. NOTICE Failure to replace your water temperature regulator on a regularly scheduled basis could cause severe engine damage. 1. Remove the cooling system filler cap slowly in order to relieve pressure. Perkins engines incorporate a shunt design cooling system and require operating the engine with a water temperature regulator installed. 2. Maintain the coolant level at the maximum mark that is correct for your application.
If the engine is equipped with a sight glass, maintain the coolant level to the correct level in the sight glass. If the water temperature regulator is installed incor- rectly, the engine may overheat, causing cylinder head damage. Ensure that the new water tempera- ture regulator is installed in the original position. En- sure that the water temperature regulator vent hole is open. 3. Clean the cooling system filler cap and inspect the gasket. If the gasket is damaged, discard the old filler cap and install a new filler cap. If the gasket is not damaged, use a suitable pressurizing pump in order to pressure test the filler cap. The correct pressure is stamped on the face of the filler cap.
If the filler cap does not retain the correct pressure, install a new filler cap. Do not use liquid gasket material on the gasket or cyl- inder head surface. Refer to the Disassembly and Assembly Manual, “Water Temperature Regulator - Remove and Install” for the replacement procedure of the water temperature regulator, or consult your Perkins dealer or your Perkins distributor. 4. Inspect the cooling system for leaks. Note: If only the water temperature regulators are replaced, drain the coolant from the cooling system to a level that is below the water temperature regulator housing.