Perkins — Perkins 402F-05, 403F-07, 403F-11, 403F-15 Industrial Engines Operation and Maintenance Manual

SEBU9064 63 Maintenance Recommendations Cooling System Supplemental Coolant Additive (SCA) - Test/Add i03644948 Cooling System Supplemental Coolant Additive (SCA) - Test/ Add NOTICE When any servicing or repair of the engine cooling system is performed the procedure must be per- formed with the engine on level ground. This will allow you to accurately check the coolant level. This will al- so help in avoiding the risk of introducing an air lock into the coolant system. 1. Slowly loosen the cooling system filler cap in order to relieve the pressure. Remove the cooling system filler cap. Cooling system coolant additive contains alkali.

To help prevent personal injury, avoid contact with the skin and the eyes. Do not drink cooling system coolant additive. Note: Always discard drained fluids according to local regulations. 2. If necessary, drain some coolant from the cooling system into a suitable container in order to allow space for the extra SCA. Test for SCA Concentration Heavy-Duty Coolant/Antifreezeand SCA 3. Add the correct amount of SCA. Refer to the Operation and Maintenance Manual, “Refill Capacities and Recommendations” for more information on SCA requirements. NOTICE Do not exceed the recommended six percent supple- mental coolant additive concentration.

Use a Coolant Conditioner Test Kit in order to check the concentration of the SCA. 4. Clean the cooling system filler cap and inspect the gasket. If the gasket is damaged, discard the old filler cap and install a new filler cap. If the gasket is not damaged, use a suitable pressurizing pump in order to pressure test the filler cap. The correct pressure is stamped on the face of the filler cap. If the filler cap does not retain the correct pressure, install a new filler cap. Add the SCA, If Necessary NOTICE Do not exceed the recommended amount of supple- mental coolant additive concentration.

Excessive sup- plemental coolant additive concentration can form deposits on the higher temperature surfaces of the cooling system, reducing the engine's heat transfer characteristics. Reduced heat transfer could cause cracking of the cylinder head and other high tempera- ture components. Excessive supplemental coolant additive concentration could also result in radiator tube blockage, overheating, and/or accelerated water pump seal wear. Never use both liquid supplemental coolant additive and the spin-on element (if equipped) at the same time. The use of those additives together could result in supplemental coolant additive concen- tration exceeding the recommended maximum.

i02151646 Driven Equipment - Check Refer to the OEM specifications for more information on the following maintenance recommendations for the driven equipment: Inspection Adjustment Lubrication Other maintenance recommendations Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Perform any maintenance for the driven equipment which is recommended by the OEM.