Perkins — Perkins 402F-05, 403F-07, 403F-11, 403F-15 Industrial Engines Operation and Maintenance Manual

SEBU9064 67 Maintenance Recommendations Engine Air Cleaner Service Indicator - Inspect NOTICE Never service the air cleaner element with the engine running since this will allow dirt to enter the engine. Check for ease of resetting. The service indicator should reset in less than three pushes. Check the movement of the yellow core when the engine is accelerated to the engine rated speed. The yellow core should latch at the greatest vacuum that is attained. A wide variety of air cleaners may be installed for use with this engine. Consult the OEM information for the correct procedure to replace the air cleaner.

If the service indicator does not reset easily, or if the yellow core does not latch at the greatest vacuum, the service indicator should be replaced. If the new service indicator will not reset, the hole for the service indicator may be restricted. i02335405 Engine Air Cleaner Service Indicator - Inspect The service indicator may need to be replaced frequently in environments that are severely dusty. Some engines may be equipped with a different service indicator. i02927289 Engine Air Precleaner - Check/ Clean Some engines are equipped with a differential gauge for inlet air pressure.

The differential gauge for inlet air pressure displays the difference in the pressure that is measured before the air cleaner element and the pressure that is measured after the air cleaner element. As the air cleaner element becomes dirty, the pressure differential rises. If your engine is equipped with a different type of service indicator, follow the OEM recommendations in order to service the air cleaner service indicator. The service indicator may be mounted on the air cleaner element or in a remote location. Illustration 38 g01453058 Typical engine air precleaner (1) Wing nut (2) Cover (3) Body Remove wing nut (1) and cover (2). Check for an accumulation of dirt and debris in body (3).

Clean the body, if necessary. Illustration 37 g00103777 Typical service indicator Observe the service indicator. The air cleaner element should be cleaned or the air cleaner element should be replaced when one of the following conditions occur: After cleaning the precleaner, install cover (2) and wing nut (1). Note: When the engine is operated in dusty applications, more frequent cleaning is required. The yellow diaphragm enters the red zone. The red piston locks in the visible position. Test the Service Indicator Service indicators are important instruments.