Perkins — Perkins 402F-05, 403F-07, 403F-11, 403F-15 Industrial Engines Operation and Maintenance Manual

68 SEBU9064 Maintenance Recommendations Engine Crankcase Breather - Replace i05335963 Engine Crankcase Breather - Replace NOTICE Make sure that the components of the breather as- sembly are installed correctly. Engine damage may occur if the breather assembly is not working correctly. NOTICE Keep all parts clean from contaminants. 4. Install a new diaphragm and plate (4) for the breather assembly into the cavity (5) of the valve mechanism cover. Contaminants may cause rapid wear and shortened component life. 5. Install a new spring (3). 6. Install the breather cover (2) and the four screws (1). Tighten the screws. i02323089 Engine Mounts - Inspect Note:

The engine mounts may not have been supplied by Perkins . Refer to the OEM information for further information on the engine mounts and the correct bolt torque. Inspect the engine mounts for deterioration and for correct bolt torque. Engine vibration can be caused by the following conditions: Incorrect mounting of the engine Deterioration of the engine mounts Loose engine mounts Any engine mount that shows deterioration should be replaced. Refer to the OEM information for the recommended torques.

i05164949 Engine Oil Level - Check Illustration 39 g03380583 Typical example (1) Screws for the breather cover (2) Breather cover (3) Spring (4) Diaphragm and plate (5) Cavity (6) Vent hole Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin. 1. Loosen the screws (1) and remove the breather cover (2) from the valve mechanism cover. 2. Remove the spring (3). Remove the diaphragm and plate (4). 3. Clean the vent hole (6) and the cavity (5) in the valve mechanism cover.