SEBU9064 69 Maintenance Recommendations Engine Oil and Filter - Change i05336039 Engine Oil and Filter - Change Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin. NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. Illustration 40 g03317856 (Y) ADD mark. (X) FULL mark.
(A) Original oil level gauge (B) Alternative oil level gauge NOTICE Keep all parts clean from contaminants. NOTICE Perform this maintenance with the engine stopped. Contaminants may cause rapid wear and shortened component life. Note: Oil gauge (A) or oil gauge (B) may be installed in the engine. 1. Maintain the oil level between ADD mark (Y) and Do not drain the oil when the engine is cold. As the oil cools, suspended waste particles settle on the bottom of the oil pan. The waste particles are not removed with the draining cold oil. Drain the crankcase with the engine stopped. Drain the crankcase with the oil warm.
This draining method allows the waste particles that are suspended in the oil to be drained correctly. FULL mark (X) on oil level gauge (1). Do not fill the crankcase above FULL mark (X). NOTICE Operating your engine when the oil level is above the FULL mark could cause your crankshaft to dip into the oil. The air bubbles created from the crankshaft dipping into the oil reduces the oil's lubricating char- acteristics and could result in the loss of power. Failure to follow this recommended procedure will cause the waste particles to be recirculated through the engine lubrication system with the new oil.
Drain the Engine Oil After the engine has been run at the normal operating temperature, stop the engine. Use one of the following methods to drain the engine crankcase oil: 2. Remove the oil filler cap and add oil, if necessary. Clean the oil filler cap. Install the oil filler cap. If the engine is equipped with a drain valve, turn the drain valve knob counterclockwise in order to drain the oil. After the oil has drained, turn the drain valve knob clockwise in order to close the drain valve. If the engine is not equipped with a drain valve, remove the oil drain plug in order to allow the oil to drain. After the oil has drained, the oil drain plug should be cleaned and installed.